4
5
4
TO INSERT THE TUBING
, push tubing into collar until you
feel resistance, Then push in again approximately 1/4 inch
farther.
TO REMOVE THE TUBING
, push in slightly on the tubing,
then push in the connector collar while you pull gently on the
tubing to remove it.
DO NOT pull on or remove the tubing without
pushing in the collar; it will damage the connector.
When not being used, the MH EDS-O2D1 unit, oxygen tubes, cannulas, etc., should be disconnected from the oxygen supply and
stored in a secure manner to ensure that dirt and debris do not enter the inlet and outlet tubes. The supplied tote bag or a zip-top
plastic bag is a good storage container.
If the unit is not going to be used for 30 days or more, remove the
batteries. When using the unit for the first time after storage, check the batteries to ensure proper
operation. A set of fresh spare batteries should be part of your pre-flight inventory.
DO NOT store the EDS unit while the inlet is under pressure.
Remove all sources of oxygen pressure and secure the
unit to ensure it will not become damaged. If the lines are disconnected they must be covered so that debris, dust or dirt can’t get
in. If the supply line is left hooked to the system, make sure that it is first purged with clean dry air or oxygen before the EDS unit is
connected.
If the lines are disconnected they must be covered so that debris, dust or dirt can’t get in.
MOUNTING THE MH EDS-O2D1
You may mount the MH EDS-O2D1 unit to a suitable place using the supplied piece of 3M DUAL LOCK tape. Peel the protective
backing off one of the rectangles to expose the adhesive and apply it to the back of the unit above the thumb indent for the bat
-
tery door. DO NOT COVER ANY PART OF THE BATTERY DOOR. When a suitable place to mount the unit has been found, peel off the
protective adhesive backing on the other rectangle and press the adhesive side to the chosen mounting area.
Let the adhesive
cure for 12 hours before attempting to remove the two halves of the Dual-Lock from each other, or
the adhesive may pull away from the unit or mounting area.
INSERTING AND REMOVING THE BATTERIES
STORING THE MH EDS-O2D1
1. Push in the collar
2. Pull the tube
straight back
while pushing
in the collar.
INSERTING AND REMOVING THE TUBING
Remove the battery door by pressing down gently on the battery cover flange
then slide the door out and away from the unit. The O2D1 unit uses two (2)
standard AA alkaline batteries. Insert the batteries as shown on the label
inside the battery compartment (they will be a tight fit), then replace the door
by sliding the door into place until it snaps in place. Take care when removing
and replacing the batteries as to not damage the batteries and/or connectors.
Recommended Batteries:
2 each 1.5 volt DURACELL ULTRA alkaline
batteries type ‘AA’ or equal quality equivalent.
Battery Life:
100 Hrs. @ ~25° C. @ ~25% R.H. Measured from
mean, assuming fresh DURACELL ULTRA alkaline batteries operating under
normal operating conditions.
Batteries should be replaced annually or when voltage is low.
