MGI Zip X4
User Manual
19
18
9.0 Preventative Maintenance Program
To properly provide for the continued operation of your MGI
Zip buggy, MGI has introduced its Preventative Maintenance
Program [PMP]. The PMP consists of work to be carried out by
both the owner and authorised service centres. To maintain the
warranty of your MGI motorised buggy, it is essential that this work
is carried out. If the work carried out by the authorised service
centre is to replace parts that are part of the maintenance
schedule, the owner will be charged for the parts and labour. If
the work to be carried out is part of warranty, MGI will bear the
cost.
9.1 Cleaning Your MGI Zip Buggy [See Maintenance Schedule]
For years of good operation, your buggy requires care and
attention:
•
Keep your buggy clean by using a cloth with warm water
and a mild detergent.
•
Do not hose down your buggy under any circumstance, as
the buggy has electronic components.
•
Ensure that the seat stem bracket is free from sand.
•
Do not submerge your buggy in water as it will cause
irreparable damage.
•
Clean the buggy battery base when the battery is removed
from the buggy.
9.2 Rear Wheel Axles Maintenance [See Maintenance Schedule]
The rear wheel stub axles need to be lubricated regularly. Remove
the rear wheels by depressing the spring clip and at the same
time pull off the wheel. Apply Petroleum Jelly or light grease to
the stub axles. Use a very small amount as the grease can attract
sand. If you play in sandy conditions you should clean the axle
and regrease monthly.
9.3 Upper and Lower Bag Strap Maintenance [See Maintenance
Schedule]
The bag straps should be replaced as per the Service Schedule.
The upper bag strap can be replaced by:
•
Removing the left and right hand straps form the upper bag
support.
•
Undo and remove the screws holding the strap in position on
the bag support.
•
Remove and replace both bag straps.
•
Insert bag strap securing screws.
9.4 MGI Service Schedule
It is the owner’s responsibility to ensure that all periodical checks,
necessary adjustments and services are carried out. If in doubt
please contact the MGI service centre on 1300 644 523. Any work
performed on your buggy should be recorded on your service
record (see page 21) regardless of the work.
MGI Zip X4
Monthly
6
Monthly
Every
2 yrs
Every
3 yrs
Wipe down the
buggy with a warm
cloth after each use
[do not hose]
BO
Lubricate rear wheel
stub axles
BO
Check and tighten
nuts and bolts
BO
Check and tighten
handle pivots
BO
Check alignment of
buggy – ensure that
it runs straight
BO
Replace Speed
Controller and On/
Off switch assembly
BO /SC
Replace rear and
front wheels
BO
Replace upper and
lower bag straps
BO
BO = Buggy owner can carry out this work
SC = Charged work to be carried by approved service centre
BO/SC = The six monthly service can be completed by either an
authorised service centre or the owner of the buggy.
Содержание ZIP series
Страница 1: ...User Manual VERSION 1 0 ...
