MGI NAVIGATOR QUAD GYRO, Руководство пользователя

Страница: 12 / 15

22
15.2 Rear Wheel Axles Maintenance [See Maintenance Schedule]
The rear wheel stub axles need to be lubricated regularly. Remove
the rear wheels by depressing the spring clip and at the same
time pull off the wheel. Apply Petroleum Jelly or light grease to
the stub axles. Use a very small amount as the grease can attract
sand. If you play in sandy conditions you should clean your axle
and regrease fortnightly.
15.3 Upper and Lower Bag Strap Maintenance
[See Maintenance Schedule]
The bag straps should be replaced as per the Service Schedule.
The upper bag strap can be replaced by:
• Removing the left and right hand straps form the upper bag
support
• Undo and remove the screws holding the strap in position
on the bag support
• Remove and replace both bag straps
• Insert bag strap securing screws
15.4 Correcting the Alignment
See the front wheel alignment in Section 6.2.
15.5 MGI Service Schedule
It is the owner’s responsibility to ensure that all periodical checks,
necessary adjustments and services are carried out. If in doubt
please contact the MGI service centre on 1300 644 523. Any
work performed on your unit should be recorded on your service
record (see page 5) regardless of the work.
MGI Navigator
Quad Gyro
Monthly
6
Monthly
Every
2 yrs
Every
3 yrs
Wipe down the unit
with a warm cloth
after each use [do
not hose]
BO
Clean the 5th wheel BO
Lubricate rear wheel
stub axles
BO
Check and tighten
nuts and bolts
BO /SC
Check and tighten
handle pivots
BO/SC
Check alignment of
model – ensure that
it runs straight
BO /SC
Replace Speed
Control button
BO/SC
Replace speed
controller and On/
Off switch assembly
BO/SC
Replace rear and
front wheels
BO
Replace upper and
lower bag straps
BO
BO = Buggy owner can carry out this work
SC = Charged work to be carried by approved service centre
BO/SC = The six monthly service can be completed by either an
authorised service centre or the owner of the model.
MGI Navigator™ Quad Gyro
User Manual
23