- 6 -
the Adaptor Plug into Receiver DC Jack .
Do not charge batteries in especially hot areas. Keep away from heaters etc.
1.
Receiver Collar Charging
The red LED light is on when charging .
The green LED light is on and the red LED light is off when the receiver collar is fully charged.
The Receiver red LED light will flash when the battery is low. Please then re-charge the battery at once.
2.
Transmitter Charging
The LCD display shows “CHA” when charging.
The LCD display shows “FUL” when the transmitter is fully charged.
The transmitter red light flashes if the battery is low. Please charge it promptly.
Important : When not in use for long periods, please give a full charge for transmitter and receiver collars
every month or so.
Training Guide
1.
Fitting the Collar onto your Dog
Place the collar strap in the middle of the dog’s neck. The receiver should be on the underside of his neck
although on some dog’s necks the receiver will naturally seek a slightly off-center position. The Rubber Charging
Port Cover should face downwards ( toward the dog’s chest).
Tighten the buckle by holding it with two fingers as you pull the strap snug. Remote training collars must be
put on a dog quite snugly to ensure consistent contact of both probes on the skin of your dog’s neck to give a
reliable static stimulation.
2.
Stimulation
Your Remote Trainer has 10 levels of intensity so you can find the best level for your dog’s temperament and
the type of training. You may also select either a shock or vibrate stimulation depending on your dog’s
temperament and your training purpose.
You may press the “+” or “-“ buttons to select a suitable shock level then press on the
“
”
button one time to
give one short static shock or press and hold for around 8 seconds for a continuous stimulation. The shock
cuts out automatically after the 8 seconds maximum.
You may press the “+” or “-“ buttons to select a suitable a vibration intensity level then press and hold on the
“
”
button for around 8 seconds continuous vibration or press one time for one short vibration .
Troubleshooting Guide
Problem#1: No stimulation when a transmitter button is pressed.
The receiver has not been activated. The receiver must be turned on otherwise it won’t work at all.
The receiver has not been set to your transmitter. Follow the instruction to match. The intensity is set too low
or at zero.
Problem#2: The Beeper of Receiver doesn’t make any sound when the Receiver is turned on.
Press dog selection button to choose correct Dog ID before press transmitter buzz control button.
The Beeper component is loose. Please send to the MGG service center to repair .
Problem#3: The stimulation seems too high, not high enough or no feeling at all
The collar strap is not tight enough. Make sure the contact points connect properly with the dog’s skin.
The intensity level is not correct. Change the shock level.
