- 5 -
Step 3
: Press and hold the “
” button and the “
” button at the same time until the digital number on the
LCD display changes automatically then release. The transmitter enters the “match receiver” mode .
The number changes like “08,09,10,11……”, increasing automatically .
Step 4
: Hold the transmitter close (50~100mm) to the unmatched receiver.
Step 5
: Press and hold the dog selection button which you want to match to. If you are matching dog “
1
”
then press the “
1
” button. If you are matching Dog “
2
” then press the “
2
” button etc.. After hearing
3 “beep” sounds from the receiver and seeing the green LED flash slowing down then release .
Special note: You must hear the 3 “beep” sounds from the receiver which you are matching first and
also see the green LED flash slow down before releasing the dog selection button. If your matching
fails you need to cancel the failed matched receiver then re-match again.
(See 2 below to cancel)
Step 6
: Press and hold the “
” button and the “
” button at the same time again until the digital number
on the LCD display does not change, then release.
Step 7
: Test the matched Receiver. Choose the dog first, then press the “
” button. You should hear the
“beep” sound from the matched receiver. Congratulations! You have matched the receiver
successfully .
Note: After matching a receiver collar the dog selection button will return to dog “1” by default .
Before testing the matched collar, please choose the correct dog number again first .
2.
To cancel a matched Receiver please f
ollow the steps below one by one.
Step 1 :
Take out a matched receiver . Press and hold the “ON/OFF” button. After two “beep” sounds the
receiver is switched on and the Green LED flashes once every 5 seconds .
Step 2
: Press and hold the “
” button until the LCD display turns on then release. The Transmitter is now
turned on.
Step 3
: Press and hold the “
” button and the “
” button at the same time until the digital numbers on the
LCD display change automatically then release. You should now be in the cancel matched receiver
mode and see the number changing like “08,09,10,11……”, increasing automatically.
Step 4
: Hold the transmitter close (50~100mm) to the matched receiver. Press the Dog Selection Button once.
(You can press “
1
” or “
2
” or “
3
” freely, it is the same). You should hear 2 “beep” sounds from
receiver.
Step 5
: The green LED light of Receiver flashes frequently . Press and hold the “
” button and the “
”
button at the same time again until the digital number on the LCD display stops changing then release .
Exit the cancel matched receiver mode . Congratulations! You have cancelled the matched Receiver
successfully .
Charging
The transmitter and receiver charge rapidly – only around 2 hours are needed.
The transmitter and receiver collar can be charged at same time.
There is a common charger for the transmitter and receiver.
To recharge please open the Rubber Cover first . Plug the Adaptor into a household AC power outlet and insert