7
Charging
The transmitter and receiver charge rapidly – only 2 hours or so are needed.
The transmitter and receiver collar can be charged at same time
There is a common adapter for transmitter and receiver charging
To re-charge open the rubber cover first and insert the plug into the receiver and transmitter DC Jack sockets. Then
plug the Adaptor into your household AC power outlet.
The Transmitter and Receiver Collar can also be charged by connecting USB Cable to your computer USB socket.
Do not charge batteries in especially hot areas such as inside a vehicle ,far away from a fire.
Important : When not using the products for 4 to 5 weeks, please give a full charge for both Transmitter and
receiver collar.
Receiver Collar Charging
The red Led Light is on when charging.
The green Led Light is on and the red Led Light is off when the receiver collar is fully charged
NOTE: The receiver red led light flashes if the battery is low. Charge it promptly.
Transmitter Charging
The LCD display is “CHA” when charging.
The LCD display is “FUL” when the transmitter is fully charged
Training Guide
1.
Fitting Collar on the Dog
Place the collar strap in the middle of the dog’s neck. The receiver should be on the underside of his neck although
on some dog’s necks the receiver will naturally seek a slightly off-centre position. The Rubber Cover should face
backwards (toward the dog’s chest).
Tighten the buckle by holding it with two fingers as you pull the strap snug. Remote training collars must be put on a
dog quite snugly to ensure consistent contact of the probes with the skin of your dog’s neck and therefore reliable
stimulation.
Do not put any fingers under the strap as you tighten it.
2.
Static shock stimulation
Your Remote Trainer has 10 levels of intensity so you can find the best level for your dog’s temperament and the
type of training your dog requires. You may also select either continuous or momentary stimulation depending upon
your dog’s temperament and your training purpose.
You may press “+” or “-“ button to select suitable shock level, then press the “
” button for around 8 seconds
continuous stimulation or press “
” button for momentary shock.
3.
Vibrate
Your Remote Trainer has 10 levels of vibration so you can find the best level for your dog depending upon your dog’s
temperament and your training purpose.
