8
You may press the “+” or “-“ button to select a suitable shock level then
press
the
“
” button 1 time for a brief
one time vibrate. Press and hold on
the
“
” button for up to 8 seconds continuous vibration stimulation.
4.
Highlight LED Flash Continuously
Note:
To get a highlight flash continuously on a dark night you must firstly match the receiver collar to the
Transmitter.
Press and hold on
“A”
button for 3 seconds
and
“A”
dog receiver collar will highlight flash 5
t
imes then flash 1 time
per 3 seconds continuously.
Press and hold on “
A
” button for 3 seconds again and “
A
” dog receiver collar will flash 2
times then quit the continuous flash.
Set up Dogs B and C in the same manner with buttons B and C
"
A
" dog receive collar is white highlight LED,
"
B
" dog receive collar is red highlight LED,
"
C
" dog receive collar is green highlight LED.
Troubleshooting Guide
Problem#1: No stimulation when a transmitter button is pressed.
The receiver has not been activated. The receiver must be turned on or it won’t work at all. The receiver has not
been set to your transmitter. Follow the instruction to re-match. The batteries in either the receiver or the
transmitter are dead. Recharge or replace, as needed. The level of stimulation has not been set.
Problem#2: The Beeper of Receiver doesn’t make any sound when the Receiver is turned on.
The battery in the Receiver has run down. Recharge as needed.
Loose battery connection.
The Beeper component is loose. Send to MGG for repair.
Problem#3: The stimulation seems to high, not high enough or no feeling at all
The collar strap is not tight enough. Make sure the contacts points connect the dog’s skin properly.
The intensity level is not correct. Change the shock level.
The batteries are dead. Recharge as needed.
Problem#4: The receiver light changes colour to indicate low charge very quickly
The unit has been left turned on between training sessions. Make sure the receiver is turned off after use.
You are training in very cold weather.
Problem#5: The Remote Trainer doesn’t have range or the range is significantly reduced.
Either you or the dog is shielded by a metal structure. Operate it far away from these types of structure.
The receiver is on backwards. For best range, position the receiver so that the light faces toward the dog’s nose.
Radio Interference. Wait a short while then try again, or move to another area.
Problem#6: The receiver seems not to receive any signal or cannot work at all
Check the receiver on/off button and make sure the receiver is turned on.
Check the transmitter battery, Recharge the Transmitter.
Check if you are using the correct transmitter and receivers as they are matched previously in the factory.
