5
UG-015
4.0
Technical Points
•
Laddersafe platforms must not be used on any trench sheets less than 6mm thick or sheets
in pure cantilever and the upper support frame must be no more than 1.5m below the top of
the sheet.
•
MGF Gangway Ramps are designed for man access to a Laddersafe platform – they should
only be used by 1 operative at a time and are suitable for max. 150kg point load or 1.5kN/m²
UDL.
•
Each ramp can be used at a maximum angle of 17.5° and cater for a 0.5m vertical height.
•
Up to 3 ramps can be connected to cater for a maximum vertical height of 1.5m.
•
MGF Gangway Ramps should not be used for transporting/storing plant or equipment and
equipment should not attempt to be carried down the ladder.
•
MGF Gangway Ramps are connected to the Laddersafe platform using 20mm diameter pins,
and ramps connect together using 20mm diameter pins and M16x50 grade 8.8 bolts, nuts
and plain washers.
5.0
SAFETY
Should questions regarding this manual arise, contact MGF.
Proper shoring and safety precautions must be in place if working below ground level.
Wear appropriate personal safety equipment including, but not limited to hardhat, safety
boots, safety glasses and gloves. Cover exposed skin while working on/operating the
equipment. Avoid loose clothing, jewellery, hair, or anything that could become tangled in
moving equipment.
If applicable - Ensure all safety gates are in place, orientated correctly and in good repair.
Only lift designated lifting points. DO-NOT lift by lashing to any other points as this could
cause damage, or failure.
Write a Lifting Plan, Risk Assessment and Method Statement prior to works, identifying
safety procedures as deemed necessary by an experienced operator.
Be aware of overhead obstructions including power lines.
Ensure all Bolts, pins and R-clips are securely fitted / tightened.
Inspect all components before the start of every shift.
Always provide suitable exclusion zones around the units during assembly and installation.
