3
Operating and instruction manual
1.
Compressed Air is potentially dangerous and can cause serious injury and damage. Extreme
caution is required at all times when using the compressor and accessories.
2.
Make sure that children and animals are kept well away from the compressor and respective
equipment at all times.
3.
Do not operate the compressor if any of the guards have been removed.
4.
Electrical or mechanical repairs are to be carried out by qualified engineers only. Contact
your MGF dealer in the case of any problems.
5.
Make sure that any pressure is expelled from the air receiver and the machine is
disconnected from the mains supply BEFORE carrying out any maintenance procedures.
6.
Do not leave pressure in the air receiver overnight or during transportation.
7.
Never attempt to exceed the maximum pressure: it is factory set and clearly marked.
8.
Do not run the machine in wet or damp conditions. Ensure that machine is kept dry all times.
9.
Do not operate the machine in dusty or otherwise dirty conditions. Ensure that the
atmosphere is clean for efficient operation.
10. Be sure that machine is placed in a well ventilated position to ensure the perfect cooling of
the compressor.
11. Avoid touching metal parts that get hot during operation. Wait for compressor to cool down.
12. For safe operation, adjust the pressure regulator to the recommended setting as indicated by
the specific tool or accessory being used for a particular usage and application.
13. Not spray near any flames or areas where sparks or other sources of ignition may occur.
14. Make sure that the area is well ventilated when using materials that give off fumes or sprays.
15. Always take special care with the electrical cables and hoses, making sure that they are not
put under strain, wrapped, bent or angled or in the way during usage of the compressor.
16. Make sure that air supply is switched off and all pressurized air is expelled from the
compressor and any equipment attached to it when disconnecting or attaching hoses.
17. Any equipment or accessories used in conjunction with the compressor must have a safety
working pressure exceeding that of the compressor.
18.
Make sure that any person using the compressor has read and fully understood the
information contained in this Instruction Manual
OPERATION
1.
Check that you have appropriate power supply and that the mains voltage corresponds
with that shown on plate fixed to compressor.
2.
Before plugging the electrical cable into the mains supply, make sure that the ON/OFF
switch is turned to the ‘OFF’ position (A, Fig.1). Plug in and switch on at the mains supply and
turn the ON/OFF switch to the ‘ON’ position to start the motor of the compressor.
FIG. 1
FIG. 2
C
A
B
D
