Operations
Operations
and installation
and installation
Operation instruction
•
Power key: long press ON/OFF to turn on/off the detector.
•
Sensitivity adjustment key: Adjust the sensitivity level according to the detection demands. (Long press this key
could adjust the sensitivity quickly.)
•
Reset key: Reset the background halogen level at the tip to “zero”, any level higher than this “zero” is considered to
be a leak and trigger the alarm.
•
Mute key: Set the buzzer sounds or not during the detection process.
•
Battery test key: Check the battery level.
The interface and keys of halogen leak detector please refer to Figure 2:
•
Battery Installation:
WARNING! To reduce the risk of igniting flammable gases in a closed atmosphere, batteries must be replaced in an open
area or closed space without flammable gas.
1.
See figure 3. Using a thumb to push open the battery door located at the bottom of the detector; then to remove
the door.
2.
Install two “C” alkaline batteries into the detector, observing the polarity markings on the side of the case and then
place the battery door back.
4
MGF
MGF
srl –– Via Chico Mendes, 8 – 43058 Sorbolo Mezzani (PR) Italy – Tel. +39 0521-818301 Fax: +39 0521-818202
e-mail: [email protected] –
–