Page 20 -
86-153719-00 B00
3. Operation
11
14
11
12
13
14
15
2
21
The protected equipment connected to the UPS can be energized, whether AC input power is available
or not.
Prior to initial start-up, check the UPS voltage settings. If the protected equipment voltage is other
than 208 V / 60 Hz, the UPS settings must be modified using the "UPS Driver" software
(see section 3.5).
1. Set the battery circuit breaker(s) to ON.
2. Press the ON / OFF button .
All connected equipment is energized. The buzzer sounds.
LEDs , and go ON.
If LEDs , and do not go ON or if LEDs , , or flash, there is a fault (see section 4.1).
3.3 Bargraph indications
LEDs to provide three different indications.
1. Remaining backup time in percent (in ON-LINE mode).
2. Percent load drawn by the protected equipment,
when button is pressed.
3. Operating faults (flashing LED and beeps):
Overload.
UPS fault.
Battery fault.
Excessive ambient temperature.
3.2 Start-up
18
19
20
21
15
18 19
20
11
12
13
14
24
2
11
12
13
14
Содержание 5103304 Comet EXtreme
Страница 31: ...86 153719 00 B00 Page 31...
