people, pets, clutter and debris. Never assemble or install any antenna near
power lines or residential entrance cables!
Important Warning: This antenna is an electrical conductor and, if it comes
into contact with power lines, you can be KILLED. Never assemble or
install any antenna near power lines!
Tools:
7/16" and 5/16" nut drivers, #2 phillips-head screwdriver, diagonal cutters.
Assembly Instructions:
[ ] Locate one of the 8" x 8" aluminum mounting plates and install the mast-
mount bracket using four (4) 3/8" screws and nuts. Insert screws so the nuts
install on the
mast-mount
side of the plate. This is the side that will be oriented
toward the ground during final assembly and installation.
Mounting
Bracket
Holes
Mounting Plate
[ ] Locate the second mounting plate and position it so
all mounting holes
align
with the first plate.
[ ] Install one of the fiberglass support arms as shown, inserting it between the
two plates and securing it with two (2) 1" screws and nuts. Insert screws so the
nuts install on the mounting bracket side of the plate. Finger-tighten for now –
they will be tightened later.
Mounting Plate
Install Tubes Between
the Two Mounting Plates
[ ] Install the remaining three spreader arms in the same manner.
[ ] Locate the matching-network support arm. Before installing, observe the
tube's mounting hole pattern closely. One set of holes will be closer to the end of
the tube than the set at the opposite end. Install using the pair of holes
closest to
the end
using two (2) 1" screws and nuts.
