background image

MFJ-1763 Portable Beam Antenna

Instruction Manual

4

NOTE:

 The antenna can be center or end mounted.

Once you have mounted the antenna, you are ready to hook up the coax. The coax connector is a SO-
239, so the connection should be fast and easy.

TUNING INSTRUCTIONS

Your MFJ-1763 has been preset for low SWR throughout the 2 meter band. However, the location of
the antenna might have a slight effect on its tuning. In this case it is necessary to tune the antenna.
Tuning the antenna requires an SWR analyzer such as the MFJ-208/MFJ-259 or a transceiver and
SWR/Wattmeter. This can be done in two different methods. The first method is more effective and
usually guarantees the lowest SWR.

Method 1-

 Trimmer Capacitor: Adjust the trimmer capacitor a little at a time until 

      it yields a minimum SWR. This adjustment is very coarse

      (See Fig. 1 for location of Trimmer location).

NOTE:

 Do not use method 2 unless method 1 failed

Method 2-

 Elements Length: Adjust the length of the elements by screwing them 

      in and out until minimum SWR is reached. If the SWR is not 

      satisfactory then go back to Method 1 for adjustment.

TECHNICAL ASSISTANCE

If you have any problem with this unit first check the appropriate section of this manual. If the manual
does not reference your problem or your problem is not solved by following the manual you may call
MFJ toll-free at 1-800-647-TECH (8324) or FAX to 601-323-6551, or Internet:
[email protected]. Outside of the continental U.S.A. 601-323-5869. You will be best
served if you have your unit, manual and all information on your station handy so you can answer any
questions the technicians may ask.

You can also send questions to MFJ Enterprises, INC., P.O. Box 494, Mississippi State, MS 39762.
Send a complete description of your problem, an explanation of exactly how you are using your unit and
a complete description of your station

Содержание MFJ-1763






Отзывы: