24
Generic Placement Steps
Important: DO NOT place any embers on top of the
flash tube to ensure proper operation.
Begin with the bottom log and ember placement
shown below. To complete log placement continue
to the instruction supplied with your log set.
Place the rear log (log #1) as shown. The log should
rest flat between the rear brackets and top burner.
Place the glowing embers (supplied with burner)
evenly in the areas shown. Break up any clumps
that may have developed during shipment. Keep
some embers for future placement along the front
log.
Ember placement detail.
Place the front log (log #2) as shown. Rest the log
with its back against the burner assembly behind
it. DO NOT place it forward or on top of the grate
fingers.
LOG SET, GLOWING EMBERS, AND BRYTE COALS PLACEMENT
Read all safety warnings and important information in this manual and the instructions supplied with the
log set to ensure proper placement.
DO NOT add any additional embers to this setup. Any additional embers will cause unsafe operation.
Your log set design may slightly vary from the images shown here, but initial placement is the same.
