Meyer V-FORCE 7400 Series, Руководство оператора и каталог запасных частей, Страница: 9 / 88

PB-74/7500 - 9 -
SAFETY PRECAUTIONS
This symbol is used to call attention to instructions concerning personal safety. Be sure to observe
and follow these instructions. Take time to be careful!
WARNING: BEFORE ATTEMPTING TO OPERATE THIS SPREADER, READ AND STUDY THE
FOLLOWING SAFETY INFORMATION. IN ADDITION, MAKE SURE THAT EVERY INDIVIDUAL WHO
OPERATES OR WORKS WITH THE SPREADER, WHETHER FAMILY MEMBER OR EMPLOYEE, IS FAMILIAR
WITH THESE SAFETY PRECAUTIONS.
Require anyone who will operate this spreader to read and completely understand this owner’s manual. Give
necessary instructions.
DO NOT operate, service, inspect or otherwise handle this spreader until all operators have read this Owner’s Manual and have
been properly trained in its intended usage.
DO NOT allow minors (children) or inexperienced persons to operate this spreader.
If the spreader becomes clogged, shut off the tractor engine and allow all mechanisms to stop. Disconnect PTO shaft or hydraulic
drive supply hoses (relieve hydraulic pressure). Then, clean or work on the spreader as required.
Always shut off power and disconnect PTO shaft or Hydraulic drive supply hoses (relieve hydraulic pressure) from tractor to
prevent accidental startup or unexpected movement before working on machine.
DO NOT clean, adjust or lubricate while the spreader is in motion.
Make sure all hydraulic fittings are tight and that all hoses are in good condition. Hydraulic fluid escaping under pressure can
have sufficient force to penetrate skin and cause serious injury. Never investigate for hydraulic leaks by using a part of the body
to feel for escaping fluid.
Inspect when first delivered and regularly thereafter; that all connections and bolts are tight and secure before operating.
Know how to stop the unloading unit of the spreader before starting it!
DO NOT operate until all shields, covers and guards are in place and securely fastened.
Make certain everyone is clear of the spreader before applying power.
Keep hands, feet and clothing away from moving parts. Loose or floppy clothing should not be worn by the operator.
Stay well clear of the spreader's rear and discharge spinners while operating.
DO NOT step up on any part of the spreader at any time. DO NOT use the PTO guard as a step.
DO NOT step over the power take-off shaft. Stay clear of the PTO at all times.
Keep PTO shaft telescoping tube shields turning freely. Keep PTO master shield on tractor. Replace damaged or missing shields.
Match the right tractor PTO spline and speed with the PTO driveshaft provided with the implement. This will assure proper
geometry and operating speed. Never operate 540 RPM implements at 1000 RPM. Never operate 1000 RPM implements at
540 RPM. Never use a spline adapter. Use of adaptors will void warranty due to damage caused to the tractor PTO, PTO
driveshaft, or implement.
Use only properly rated tires.
DO NOT tow at speeds in excess of 20 MPH when transporting this spreader. Never exceed a safe travel speed.
Observe all applicable traffic laws when transporting on public roadways (where legal to do so). Check local laws for all highway
lighting and marking requirements.
When towing the spreader on public roads a safety chain of sufficient strength to support, along the line of travel, the gross
weight of the spreader must be used (See Maximum Load Weight Chart in the Transporting Section). The safety chain should
be attached per diagram in the Transporting Section.
Always install a SMV emblem on spreader for transporting on roadways and keep this emblem clean and bright.
MEYER MFG. CORP. PROVIDES GUARDS FOR EXPOSED MOVING PARTS FOR THE OPERATOR’S PROTECTION;
HOWEVER, SOME AREAS CANNOT BE GUARDED OR SHIELDED IN ORDER TO ASSURE PROPER OPERATION. THE
OPERATOR’S MANUAL AND DECALS ON THE MACHINE ITSELF WARN YOU OF DANGERS AND MUST BE READ AND
OBSERVED CLOSELY!
Study the Above Safety Rules
FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.