GENERAL INFORMATION
CAUTION:
Always disconnect battery prior to
installation.
SAFTEY PRECAUTIONS
should be used when
Quik
Lift
®
is in a
RAISED
position.
LOWER
plow to the
ground when vehicle is
PARKED.
OVERHAUL and SERVICE information is covered on
separate instructions.
Note:
1. Connect ground cable to negative side of battery
for a solid connection to ground.
2. Caution: Route all cables away from moving engine
parts, Manifolds, and sharp sheet metal.
3. For weather protection, tape all elcetrical
connections at front of vehicle.
4. The vehicle must be equipped with a "Heavy
Duty Battery" (70 Amp, Hr. Min.), 550 C.C.A. and
"Alternator" (60 Amp. Min.) to obtain maximum
performance.
5. Follow these instructions explicitly. Warranty does
not apply to a Meyer product which has been
negligently or improperly assembled or installed.
INSTALLATION INSTRUCTIONS
A.
Install the V-66 Lift Assembly (1) to Lift Frame
(Using bolts supplied in the mounting carton),
with the Electric Motor toward the left hand side
(Driver's side); attach the lift ram in the outer hole
of the Lift Arm.
NOTE: If V-66 is to be used on the older style
(fixed) mountings, the unit may require being
rotated 180 degrees with the Electric Motor to the
right hand side (Passenger Side) of the vehicle.
B.
Remove shipping plug from filler hole and install
Relief Valve Kit (16). Tighten to 100 - 125
in. lbs.
C.
Install Coupler Cap and Plug (8a,b) onto Power
Angling Block per illustration.
D.
Install Pigtail (10) to Lift Unit (1) with the red
leg to the (+) motor stud and black leg to the
(-) motor stud as per figure 2A. Attach the other
black leg of Pigtail (10) to the base of the Lift
Unit (1) as per figure 2 using bolt (18) and
lockwasher (25). Place lockwasher (25) between
cable terminal and base so it bites into paint
for proper ground.
E.
When Lift (1) is removed, Protect the sockets
from corrosion by using Weather Plugs (14&15).
ADDITIONAL BATTERY CONNECTORS:
a. When attaching cables to battery with side post
terminals, use M.P. Adaptor Part # 21976 and attach
as shown in figure 1.
b. Figure 2 illustrates the method of using a repair type
terminal connector which is original equipment on
some vehicles.
. 1
. 2
1
PO
S
5
9
12
BA
TTE
RY
7B
7A
5
13
24
3
NE
G
11
10A
26
2
FAU
LT
D
FLO
AT
RIG
HT
LEFT
U
R
FIGURE 1
28
