A. Attach L.H. and R.H. Light Brackets (46 & 47) to the side plates of Lift Frame (12) in
the upper two holes using 5/16”-18 x 1-1/4” bolts (55), 5/16” lockwashers (56), and
5/16”-18 hex nuts (58). Note: Light brackets may be adjusted down two levels in
height for better appearance on lower profi le vehicles. Tighten all fasteners to their
proper torque.
Attaching Plow to EZ Build Assembly
B. Liberally coat Pivot Pins (59) with Coolube Multi-Purpose Premium Grease Part
No. 15181.
C. Attach Pivot Bar (6) to Moldboard with Pivot Pins (59) (grease fi tting facing
outward) and insert Cotter Pins (57). Grease Pivot Pin’s (59) using grease fi tting.
D. Attach Eye Bolts (54) to Moldboard and Trip Springs (35) to Pivot Bar (6), making
certain locknuts are positioned as shown below.
E. Make certain each Eye Bolt (54) is in a vertical position as shown below so that the
Eye Bolt (54) and Trip Spring (35) hinge properly when moldboard trips.
6
35
59
25
F. Attach Plow Markers (42) to moldboard using 5/16-18 x 1” Bolt (43), 5/16” Flatwasher
(45) and 5/16-18 Locknut (44)
G. Attach the Lift Chain to the Lift Arm (14) through the two hooks on the lift arm. Adjust
the lift chain at the lift arm so that there are 2-3 links of slack. This ensures that the
plow blade will lift fully and be able to follow the ground contour while plowing.
2-45
(5)
14
20
47
55
56 58
20309
20530
07031
RIB
07017
Note: Proper tension is attained when Trip Spring (35) coils just begin to separate and
then tightening top locknut four additional turns. Tighten bottom Locknut (20530)
to secure Eyebolt in position. Install Eyebolt caps (07031) over exposed threads.
