Meyer EZ-Mount Plus, Руководство по эксплуатации и обслуживанию

Страница: 8 / 36

Removing and Attaching Plus Plow
DETACHING THE COMPLETE ASSEMBLY
Leave control switch in lower float position and push down on
the Lift Arm. Disconnect the electrical plug. Attach Crankstand
to the adjustment tube on the side of the A-Frame using the
chained locking pin.
Caution: Crankstand must be secured
at all times.
Adjust the Crankstand down until the bottom of
stand touches the ground. Pull and twist the Blue Handle Pins
to disengage lift frame from clevis frame. If the pins do not pull
easily, adjust stand up or down slightly to remove tension on
the pins until they disengage. At this time the lift frame should
be leaning forward slightly, at rest on the top of the Crankstand.
Pull truck away.
ATTACHING THE COMPLETE ASSEMBLY
Check that Blue Handle Pins are disengaged. Drive the truck
up to the EZ-Mount Plus assembly centering the hood of
the truck to the lift arm to assure proper alignment with lift
frame guide plates until contact is made. Once contact is
made, drive forward, pushing the assembly a few inches. This
insures the lift frame is square to the Clevis Frame for proper
pin attachment. Adjust the Crankstand up until the front of the
truck raises slightly. Twist Blue Handle Pins so that the small leg
re-aligns with the slot, engaging the pins. The spring loaded pins
should snap into place.
Note: If pins do not lock immediately,
move truck slightly forward and/or adjust the Crankstand up
or down until pins engage, or push the top of the Lift Frame
towards the truck locking the pins to the clevis frame. Remove
the Crankstand from the A-frame by removing the chained locking
pin. Reattach the Crankstand to the transport tube on the driver’s
side of the Lift Frame in the
vertical, retracted position. Caution:
Crankstand must be secured at all times. Reattach the one
step electrical connection.
-6-