Meyer Sound 600-HP, Руководство по эксплуатации, Страница: 28 / 40

22
CHAPTER 7
The front links may be set in two different positions:
■
0°: This is the standard position (left figure) and it is
used to achieve a 0-degree angle between adjacent
600-HP enclosures.
■
+3°: The main purpose for this extended position (right
figure) is to curve a 600-HP stand-alone array that is
flown next to a MICA array, both for appearance and to
keep the subwoofer array from blocking the horizontal
high-frequency coverage from the MICA enclosures
lower in the array.
+0
+3
+0
Figure 7.3. Front GuideALInks set at 0° and +3°
RIGGING CONFIGURATIONS AND TILT ANGLES
The resulting angle from the positioning of the front and
rear links depends on whether they are being used to link to
other 600-HP subwoofers or to MICA array loudspeakers.
600-HP to 600-HP
Flown
When 600-HPs are flown, the GuideALinks allow a vari-
ety of combinations. However, the most common is at 0
degrees. In addition, when flown it is possible to achieve to
a 3-degree downtilt to curve a 600-HP stand-alone array
that is flown next to a MICA array, both for appearance and
to keep the subwoofer array from blocking the horizontal
high-frequency coverage from the MICA enclosures lower in
the array.
Table 7.1. 600-HP Link Positions to 600-HP (flown)
Rear Front Angle for 600-HP below
0 0 0°
0 +3 3° downtilt
-3
+0
+3
0 +0
0
+0
+0
+3 0
Figure 7.4. 600-HP at 0 degrees (left) and at -3 degrees
NOTE: Not all mechanically possible com-
binations between two 600-HP are useful
— for example, concave angles between two subs.
These combinations are possible because the 600-
HP rigging was designed to also allow a wide num-
ber of combinations between 600-HP when flown or
ground-stacked with MICA loudspeakers.
Ground-stacked
When 600-HPs are ground-stacked, the GuideALinks allow
a variety of combinations. However, the most common is at
0 degrees. In addition, it is possible when ground-stacked
to achieve to a 3-degree uptilt to curve a 600-HP stand-
alone array for purposes of appearance.
Table 7.2. 600-HP Link Positions to 600-HP (ground-stacked)
Rear Front Angle from 600-HP below
0 0 0°
0 +3 3° uptilt
600-HP to MICA
Flown
MICA and 600-HP loudspeakers can be combined within
the same array to supplement and extend low-frequency
headroom in the system. The rigging on both models is
completely compatible. When flown, the 600-HP sub-
woofers are typically positioned at the top, and linked to
the MICA with an uptilt or downtilt as needed to meet the
requirements of the installation.