X
4
MR
250
MexAir RC
10
5.
Frame Assembly
a.
Assemble the balance of the frame as you complete the final wiring of your
electronics. See the accompanying photos for airframe standoff placements. Note
that the upper standoff CF tubes are embedded into the main frame. They insert
into the upper side of the main frame body and rest on the lower skin surface. Prior
to insertion, check that the hole is clear of any obstruction. When finally tightened,
this creates a very rigid frame. Temporary and partial frame assembly may be
desired as you progress through assembly.
CF Tube Standoff Configuration
(Steps 5a through 5e Completed)
b.
Final tightening of the frame standoffs is done after all soldered / permanent
equipment is installed. The camera plate must be inserted into the front upper and
lower slots completely while the forward standoff fasteners are loosely fitted. The
camera plate should rest squarely on the main frame body and top plate surfaces.
Camera Plate Configuration
