MEV™ Daytona™ OWNERS MANUAL
5
General Warnings:
The following safety procedures should be followed during cart operation, maintenance or
repair. Other special warning signs are described in this manual.
The cart contains batteries, which can emit quantities of explosive gases. Keep the cart in a well-‐
ventilated area and away from sparks and open flames.
Do not cover the cart while charging as an accumulation of hydrogen gas could result in
explosion.
When charging the cart be sure that the ignition is switched to the OFF position. If the key is left
in the ON position damage may be caused to the charger or the car.
The cart is equipped with an on board UL listed charger. When charging your car please be sure
to use a proper grounded charging cable to provide power to the charger. Ventilate when
charging or operating the cart in enclosed areas.
Do not perform service or maintenance on batteries while cart is charging.
The cart does not offer protection from lightning, flying debris, or other storm hazards. Upon
indication of severe weather condition, seek appropriate shelter immediately.
Always obey all traffic and course regulations when operating the cart.
Inspect battery terminals, cables and batteries before each use.
Always wear a full-‐face shield, rubber gloves and rubber apron when working with or in close
proximity to batteries.
Turn the ignition switch to the OFF position, remove the key, place the drive into park, set the
park brake and unplug the charger before inspecting or performing any type of service on the
cart.
Connections should be tight and free of corrosion.
Use insulated tools only when working with electrical connections.
The tightness of the battery terminal nut should be between 95-‐105 inch pounds of torque. Do
not over tighten. Loose and/or over tightened connections can cause battery failure, explosion
and or fire.
DANGER
WARNING
