MEV™ Daytona™ OWNERS MANUAL
22
If the charger is left connected to AC power supply, a refresh charge will occur after 10 days if
the battery voltage has dropped below a pre-‐programmed level. If a refresh charge tries to start,
but the AC power is disconnected, the charger will wait 8 days for AC to be restored.
At this point, the charger will go into sleep mode and a DC disconnect will be required to reset
the charger.
The charger can be connected to any three prong 110-‐240 volt home outlet with an available
minimum 12 amps of current. To avoid the risk of electrical shorting, the battery charger must be
grounded through a properly installed three prong outlet. Do not use a two prong adapter.
Locate all cords and wires in locations that will not be driven over or present a tripping hazard.
Note: The cart and charger are equipped with an interlock device; the cart will not start if AC
Power is pressed. The AC power source must be disconnected first at the cart connector located
on the front bumper prior to operation.
•
Do not attempt to service the charger. If the charger requires service, take it to an authorized
MEV dealer or an approved technician.
•
Do not overload the AC circuit. The input voltage of the charger should be between 110-‐240
volt and supply a current at least 12 Amps.
•
The AC side of the charger uses a grounded three prong plug. While charging, use a three
prong wall receptacle with a proper ground. Do not attempt to alter the charger plug in any
way.
•
Do not use an adapter plug to go from three prongs to a two prong outlet. This will result in
an ungrounded condition and increase the risk of electric shock and/or fire.
•
If an extension cord is used, it must also be a three pronged extension cord with 14 AWG
(American Wire Gauge) wires. No longer than 15m (50 feet). The longer the cable used
means the less effective the charge rate will be.
•
Inspect and replace the charger if it has been damaged in any way. Inspect the cords and
connectors for cracks and fraying. If cracks or frays are detected, replace immediately.
•
Do not use the charger near volatile liquids such as gasoline, paints, thinners, and other
flammables. The charger can ignite flammable materials and vapours.
•
Do not cover or block the cooling slots on the charger as it could potentially overheat.
WARNING
