Metz mecablitz 52 AF-1, Руководство по эксплуатации

Страница: 158 / 298

158
k
7 Flash modes
There are different flash modes available
depending on the camera type, for example
, , manual flash mode ,
, remote master , remote slave
flash mode as well as servo mode
.
The flash mode is set using the touch
display.
A data transfer between flash unit and came-
ra is necessary before setting flash mode
and , e.g. by actuating the
shutter release.
7.1 E TTL- and E TTL II - flash mode
These flash modes offer a very simple
method of obtaining very good flash shots.
Here, the exposure is measured by a sensor
in the camera.
It measures the light reflected by the subject
through the lens (TTL = "Through The Lens").
If the shot was exposed correctly, the correct
exposure indication will illuminate for about
5 seconds (see 4.2).
Please note whether there are limitations for
your camera in terms of film sensitivity for
E TTL flash mode (for example, ISO 64 to ISO
1000; see camera's operating instructions)!
E TTL HSS E TTL
M HSS
M
MASTER
SLAVE
SERVO
M HSS E TTL HSS
When taking a shot, an almost imperceptible
measurement pre-flash is triggered by the
camera prior to the actual exposure process.
Setting the mode of operation
• Switch on the flash unit with the
button.
The start screen appears. Thereafter, the
flash unit always switches on with the
mode of operation that was used last
(e.g. M flash mode).
• Press the displayed mode of operation on
the touch display as many times as it takes
for the display for selecting the mode of
operation to appear.
• Press the sensor buttons on the
touch display and select the desired mode
of operation.
• Press on the selected mode of operation
that is highlighted in black. The setting is
adopted immediately.
• Set a suitable mode of operation on the
camera, e.g. P, Tv, Av, M etc.
• Tap the shutter release to transfer data bet-
ween the flash unit and the camera.
52AF-1
CAN
E TTL
INFO
EV
0,3
-3,5 m
Z
OOM
35 F4.0
m
m
E TTL
M
M
INFO 1/1
4.4 m
Z
OOM
35 F4.0
m
m