Metso JAMESBURY EASYFLOW SC Series, Инструкция по установке, обслуживанию и эксплуатации

Страница: 7 / 12

IMO 3/20
IMO-503 EN 7
7.3 Rear cover disassembly
1. Loosen the cylinder cover bolt (6) of rear cover (2),
thereby remove rear cover (2) from tube (15).
2. Remove o-ring (12) and cushion seal (11), take out
cushioning screw (8) with o-ring (20).
3. Clean it with liquid soap solution. After drying apply
grease on rubber parts. Replace these rubber parts.
7.4 Tube
1. Clean with soap solution. After drying apply thin layer of
grease inside the tube (15) to make it ready for assembly.
8. ASSEMBLY
NOTE: Follow the sequence as given below to ensure proper
assembly.
8.1 Rear cover assembly
1. Clean it with liquid soap solution. After drying apply
RMEBS grease on rubber parts.
2. Place Cushioning seal (11) and o-ring (12) on its groove.
Place o-ring (20) on cushioning screw (8), assemble the
cushioning screw on rear cover.
3. Place the rear cover (2) on the tube (15), just push while
rotating to get fixed on it so that o-ring on the cover
should not get damaged while assembling.
4. Fasten the cylinder cover bolt (6) of rear cover (2).