Made by ALL Engineering
Operation
Remark:
When the Jade is fully connected and switched to ”on”
the volume knob will turn anti clockwise to the lowest position.
Also the mute function will be activated the very first time. To
release the mute function one of the remote control buttons
should be used. In case of disconnecting the Jade from the
mains power, this procedure should be repeated!
•
Standby position :
To reduce power the Dac board will be switched off in stand-by mode.
Just the front panel is activated to control the system. Power consumption will be reduced
to 0.5 Watts. Any control is possible by using the front button or remote control.
•
Mute function:
By switching to one of the digital sources the mute function will be released
after five seconds. When switching the Jade to “standby mode” muting will be active again.
When the Jade is operational you can use the mute function only by using the remote
control. In this situation the Jade shows you the selected digital source but also the red
“Standby/ mute” light will lit. By using one of the volume buttons the mute function is
released.
•
Source selection:
The digital inputs can be selected by using the only available button at the
front . When switching the Jade to “On”, the first channel (AES/EBU) will be selected. When
pushing this button repeatedly, the next “coax ” input will be selected followed by “Optical”
and “USB”. The next step is back to “Standby” Note: When moving fast trough the Standby
mode the Jade will not switched off. Only when waiting for a few seconds the Jade will go
into standby mode when selected.
•
Error indication:
When no digital data is coming in, the orange “Remote /Error” led above
the remote sensor will lit.
•
Remote indication:
When using the remote control the Remote/ Error led will flash rapidly.
