Metronic TouchBOX 3, Руководство пользователя

Страница: 10 / 48

10
2 - Installation of a fi xed dish on a satellite
Read the installation advices, and particulary the paragraph E (page 9).
A - Connections
The receiver must be disconnected from the mains, connect directly the LNB to the LNB
input of the receiver. Connect the television to the receiver scart socket output. Switch on the
television and connect the receiver to the mains. The green LED lights on. The red LED is
ON. Press the power key (
) of the remote control, the greenLED lights on. If the television
does not display a black screen with a message «BAD OR NO SIGNAL», check the scart
leads connections and/or force the A/V or EXT mode of your television (see your TV user
manual).
B - Alignment / Satellite dish orientation
Find in Table 1 (page 9) channel number of the reference channel of the satellite that you wish to receive
(example: 400 = BBC ONE for Astra 28°). Type on the remote control the channel number.
Press on the remote control INFO key to show the reception level. This indicator shows normally 0%; the
alignment will consist in directing the satellite dish toward the satellite, leading to a maximum level and
quality.
Beware, it may be useful to search for the south with a compass. However, never use a compass to find the
supposed location of a satellite. For instance, you may guess that Astra 28° is located 28° left from south.
It’s false! Just sweep the dish as explained, this method works better.
Put the satellite dish in a vertical position (the graduations on the back show 20-25°) and roughly direct it
towards the south. Make a slow sweeping (about 20 seconds) of a quarter of a spin on the left then a quarter
of a spin on the right while checking on the television. The indicator should not show anything at this stage.
Incline the satellite dish of 2 degrees (a little less than 1 inch at the top of the dish) towards the top and then
start again the sweeping.
Proceed by 2 degrees steps until the indicator goes up and that the channel appears. Tighten all the screws
definitively, except those which fixing the LNB in its holder. If the indicator increases, but no images appear
on the screen, it means you are on another satellite, it is necessary to continue sweeping.
C - Adjustment of the polarisation
Rotate the LNB clockwise in its holder for a few degrees to further increase the quality of signal. If the
signal decreases, rotate it in the opposite direction.
Once you obtain the best signal, tighten definitively all the screws. Your installation is finished. Press on
EXIT to hide the information banner. You can now watch all the satellite channels from the satellite you just
aligned your satellite dish on.