6
If you already have a satellite dish pointing towards the Astra satellite 28.2 E, this Quick Start
Guide will help you to install your Freesat receiver in a couple of minutes.
In case of difficulty, you can always return to the factory settings by following the instructions
in this manual (p14).
• Connect the HDMI lead (supplied) to both your
TV set and the Freesat receiver.
• Connect the cable that comes from the satel-
lite dish to the input marked ANT at the rear of
the receiver.
• Plug in the power supply to the DC unit on the
back of the receiver and then to the mains.
• Insert the batteries into the remote control
ensuring the correct polarity.
• If the front LED is on, press the
key of the
remote control to switch the receiver on.
• The TV screen should display the screenshot
below (01), if this is not the case check that
your HDMI lead is connected (see the user
manual of the TV if necessary).
• For a standard Freesat installation press
the
6
arrow of the remote control to select
START SCAN
. Press OK to go to the second
screen (02).
• You now have to enter your postcode.
• Press the appropriate keys to select the letter
or figure.
• Press the select key until the correct post code
has been entered then press OK to confirm
.
(FOR A 6 DIGIT POSTCODE PLEASE
SELECT THE RIGHT ARROW KEY TO LEAVE
A SPACE AFTER THE FIRST 3 DIGITS).
• The receiver will start to scan the channels automatically – this will take approximately 2
minutes (03).
• When the installation of the channels is complete the first channel to be displayed will be
BBC 1.
1 - Quick start Guide
01
02
03
