15
Wait until the reading of the file is completed and
•
when the message “Do you want to update?”
appears, select
YES
to perform software upgrade.
Please wait until
•
Programming Flash
process
completed (do not switch off the power or remove
the USB device during this process).
Reset to default in the
•
Set Defaults menu
.
Remove the power cord from the set-top box, and
•
insert it again to reboot the receiver.
Set Defaults:
You may restore to system default settings in this menu.
If you select
YES
, the system will restore to factory
default and all current settings and data will be elimi-
nated.
Cannot lock signal:
Make sure your reception systems are correctly installed and connected correctly to the
•
receiver.
Make sure the postcode is correctly entered.
•
Make sure that the antenna setting in the menu is correct.
•
No video:
Make sure that the product is powered on and in operation mode.
•
Make sure that the AV cable is firmly connected to the TV.
•
Make sure that the antenna cable is properly connected to the product.
•
Make sure that the antenna setting in the menu is correct.
•
Check the brightness level of the TV.
•
Check if the channel is currently on air. Contact the broadcaster to ensure that the channel
•
is running.
No audio:
Check the receiver and your TV’s volume are properly set and not in «mute» mode.
•
Check the audio connectors are correctly and firmly connected
•
Make sure the receiver is switched to the correct Audio mode in the menu.
•
10 - Trouble Shooting
