Metronic 441360, Руководство пользователя

Страница: 11 / 36

11
A - Installation of a bi-head satellite dish
If the receiver has factory settings (brand new or after reset of the
unit), you don’t have to modify the settings to drive a monobloc
(dual-head) LNB dish aimed at Astra 19° (Port B) and HotBird
(port A). In that case, install the monobloc as depicted below and
align the dish on HotBird as explained in the previous paragraph.
In the general case, the following text explain how to alter the
settings to declare a DiSEqC 1.0 switch.
Caution : if you want to take advantage of twin tuner, you
need a twin outputs monobloc.
• Go to MENU / Installation menu / Antenna installation.
• On the line Antenna , select 1 with keys
34
• On the line Satellite , if necessary, select HotBird
with keys
34
• On the line DiSEqC , select Port A with keys
34
• Select same way the satellite 2, Astra 19 , on the
Port B .
• Press EXIT, confirm with OK and press two times
on EXIT to save and exit.
Alignment of the dish
• Install the monobloc on the dish arm as depicted on the figure.
• Align the dish on HotBird as explained in the paragraph page 10.
• Check that you receive channels from both Astra and HotBird.
• If not, adjust the alignment to receive perfectly both satellites.
Caution : some models of monobloc may have a reverse setting. In that case, you
must change the programming of the receiver (Astra on input port A and HotBird
on input port B).
3 - Installation on several satellites
Once you obtain the best signal, tighten definitively all the screws. Your installation is finished.
Press on EXIT to hide the information banner. You can now watch all the satellite channels
from the satellite you just aligned your satellite dish on.
D - Twin tuner connection
If you have installed a twin LNB, connect the second LNB’s output
to the LNB’s input (B) of the receiver. You will also connect the
VCR scart to the VCR, as notice further in this user manual.