Metrologic MK9520-37A38, Инструкция по установке и эксплуатации

Страница: 15 / 56

11
Figure 10.
I
NSTALLING THE
S
CANNER TO THE
H
OST
S
YSTEM
Integrated USB: Full Speed (-40)
Low Speed (-38)
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector of the USB cable into the
jack on the scanner. You will hear a
‘click’ when the connection is made.
3. Connect the other end of the USB
cable to the host USB port.
4. Turn on the host system.
As a default, the MS95
x
0 -38 leaves the factory with USB Keyboard
Emulation Mode enabled.
For information on configuring the MS95
x
0 -38 for USB Serial
Emulation Mode, please refer to the USB section of the MetroSelect
Single-Line Configuration Guide (
MLPN
00-02544).
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. Please refer to the MetroSelect Single-Line Configuration
Guide or MetroSet
2 ’s help files for instructions on changing the
scanner’s factory default configuration. The scanner and host system
must use the same communication protocols.
See caution on page 6.