4
Scanner Installation
Important Note:
To maintain compliance with applicable standards, all
circuits connected to the scanner must meet the requirements for SELV (Safety
Extra Low Voltage) according to EN 60950.
1.
"Power off" the host system.
2.
Connect the communication cable to the host device.
3.
Plug the scanner cable to the communication cable.
Note:
The pin assignments for the scanner cable are listed on
page 29.
4.
"Power on" the host system.
Note:
When the scanner
first
receives power, diagnostic prompts
are displayed then the scanner "beeps." "READY TO
SCAN" appears on the display.
Configuration to the Host System
Before the scanner ships from the factory, the factory programs the scanner to
a set of default parameters. However, many functions of the scanner can be
modified to meet your individual needs. The scanner’s parameters can be
modified by entering the program mode and scanning the appropriate bar
codes that appear in the Programming Guide. For a list of various parameter
settings, refer to the Default Settings section in this guide. To modify the
settings, refer to the Programming Guide.
