*
*
D
F
1
25
Appendix C
Programmable Bar Codes
The IS4320-41 ScanKey™ is shipped from the factory programmed to a set of
default parameters. Defaults are noted on the previous pages.
1.
Connect the scanner to the host system or power source.
2.
Scan the ENTER/EXIT PROGRAM MODE bar code. (The unit will
beep three times.)
3.
Scan by positioning the output window within two inches of each code.
(When you scan the first menu selection, the laser will stay on until you
scan the ENTER/EXIT PROGRAM MODE code again. If no scanning
occurs for 30 seconds while the scanner is in program mode, the unit
will beep three times and all changes made will be lost. If this occurs,
return to Step 1.)
4.
After completing the scanning of the appropriate configuration options,
scan the ENTER/EXIT PROGRAM MODE bar code again. (The new
options will be saved and the scanner is ready for normal operation.)
Enter/Exit
Program Mode
If during the programming of the scanner, there is a need to return the scanner
to the original factory settings, scan the RECALL DEFAULTS bar code. Any
settings selected during that session or any previous session will be lost.
Recall Defaults
