Insert a new module for the Multi Autolab Cabinet
Figure 24 – Example of analog bus connections to the M101 or M204 modules installed in Parent
positions
5
– Multi Autolab M101 or M204 programming
When M101 or M204 modules
are installed into an existing Multi Autolab Cabinet, two
situations can be encountered:
1.
The M101 or M204 module was ordered for a known Multi Autolab Cabinet and
for a known position in the cabinet (1-6 for the Parent positions or A-F for the
Daughter positions). In this case, the module has been programmed by Metrohm
Autolab and it will be recognized properly by the software. The module will be
identified by the serial number of the cabinet and the location in the cabinet. For
example, module MAC80002#A will indicate a M101 module located in module bay
A in the Multi Autolab Cabinet with serial number MAC80002 and module
MAC90003#B will indicate a M204 module located in module bay B in the Multi
Autolab Cabinet with serial number MAC90003.
2.
The M101 or M204 module was taken from stock and is installed into an unknown
position of an unknown Multi Autolab Cabinet. In this case, the module needs to
be programmed in order to be recognized properly. If the module is not
programmed, it will not be recognized by its position but by its native serial number
1
Only M101 modules need to be programmed. This is not required for optional modules installed in Daughter
module bays.
19 |
P a g e
