Metrohm 793 IC, Инструкция по эксплуатации

Страница: 23 / 50

2.4
2.4 2.4
2.4 Connection
Connection Connection
Connection to
to to
to aaaa Modular
Modular Modular
Modular IC
IC IC
IC System
System System
System for Cation Elimination
793 IC Sample Prep Module/ 8.793.1003 Instructions for Use
19
2.4.2 Connection of the SP Module A
The following description implies the usage of the 2.733.0130 IC
Separation Center (one in MSM).
The 1.793.0110 SP Module A must first be inserted in the 733 IC
Separation Center and connected to the 793 IC Sample Prep Module.
The connection of all parts should be done as described by the
following scheme:
Fill
A
SP
Module
A
793 709
MSM
752
Inject
A
SP
Module
A
793 709
MSM
752
Regenerant Eluent H
2
O
Regenerant Eluent H
2
O Regenerant H
2
O
Regenerant H
2
O
The inlet and outlet capillaries mounted on the SP Module A are then
connected up. Proceed as follows:
1 Insert SP Module A
x
Place SP Module A 21 21 21 21 on the floor of the inner chamber of
the 733 Separation Center.
2 Connect SP Module A
x
Remove the plastic stopper from opening 41 41 41 41 or 43 43 43 43 on the
733 IC Separation Center and push cable
23
23 23
23
mounted on the
SP Module A 21 21 21 21 through the opening.
x
Connect cable 23 23 23 23 to connection 17 17 17 17 “Actuator“ of the 793 IC
Sample Prep Module (see Fig. 8 ).
3 Connect sample line to 793 SP Module A
x
Screw inlet capillary 24 24 24 24 marked with "Sample in" at SP Module
A connection 22 22 22 22 (see Fig. 6 ) onto a 6.2744.040 PEEK
coupling using a 6.2744.010 compression fitting. Connect
this PEEK coupling with the PEEK capillary from the 766 IC
Sample Processor using a 6.2744.010 compression fitting.
A) In the SP Module A
Cations of the sample
are continuously
exchanged by H + ;
Sample loop is filled.
B) Pretreated sample is
pumped to the
separation column.
Sample
Sample
Separation
column
Separation
column