metrofires ECO Mega Smart Built-In Скачать руководство пользователя страница 10

10

Flue systems

Should be checked annually, particularly the bottom end 
of the lower fl ue section at its rear lock formed joint. If 
deterioration is noticed contact your Metro retailer or installer.

The fl ue pipe should also be swept a minimum of once a year, 
or as required during the winter season. If smoke enters the 
room when you open the Metro’s door this usually indicates 
the fl ue pipe is becoming restricted and needs cleaning. The 
frequency of fl ue pipe cleans depends on many factors, with 
the main variables being: 

•  The seasoning of the wood. If not properly seasoned you 

will require frequent fl ue pipe cleans.

•  The density of the wood. Softwoods generally result in more 

deposits building up in the fl ue pipe.

To clean the fl ue pipe of your Metro, proceed as follows:-

 

•  Open the Metro’s door fully, reach inside with the palm 

of your hand face-up and extended, lift the top baffl e 
approximately 20mm, then lift it forward out through the 
door opening, placing it on a sheet of newspaper you 
have placed on the front of the fl oor protector.

Note: Some appliances have a two piece top baffl e.

•  Close the door and slide the air control to the left.

•  Once on the roof, remove the cowl from the top of fl ue 

system and sweep the fl ue pipe using a 150mm-diameter 
fl ue pipe brush as detailed in the instructions provided with 
the fl uebrush.

•  Once the fl ue pipe is clear, clean and refi t the cowl. 

Remove the excess soot which has fallen into the fi rebox, 
leaving a layer of ash 10mm deep on the base of the 
fi rebox, then refi t the top baffl e.

Note: The baffl e must be fi tted so its rear is touching the back of the 
fi rebox; if uncertain refer to previous page 9 in the installation section of 
this manual, which shows illustrations of the baffl e location.

Cleaning and maintenance for your Metro wood fi re

Parts guide for your Metro – Baffl e, promet and wetback

Listed below are the parts and product codes for your Metro 
wood fi re. The promet/baffl e should be regularly checked and 
must always be in place during the operation of your fi re.

Note: Cracks in the promet are not uncommon and have no adverse 
effect on the operation of your Metro. These cracks are the result of 
intense heat coupled with expansion and contraction and is normal 
wear & tear.

Your Metro wood fi re must be regularly maintained and we 
recommended it is also serviced annually. If a wood fi re is 
not regularly maintained and serviced, the life span will be 
reduced. If your Metro wood fi re has been neglected, by not 
being regularly maintained and serviced, with authorised Metro 
parts replaced as required, your warranty may be declined.

Clean air model

Type of promet required / Type of steel baffl e(s) required

Water heating options

• Mega Smart

ECO Mega Smart Front

500-1895

ECO Mega Smart Ctr-Rear Set 

500-1900

ECO Mega Smart Front 500-2450

ECO Mega Smart/Ambie Plus 

Rear 500-2500

ECO Mega Smart Booster 

450-0400

500mm

130mm

500mm

247mm

500mm

125mm

500mm

70

85

Содержание ECO Mega Smart Built-In













Отзывы: