3
Metro Ambience Series
To minimise freight damage, the pedestal base has been
packaged inside the firebox and the pedestal mount plate
has been packaged up against the door glass for added door
glass protection during transit.
Please note: you should only assemble this wood fire if you are
suitably experienced in wood fire assembly and installation.
To safely assemble your Metro, please proceed as follows: -
- Safely remove straps by cutting straps with scissors.
- Lift off carton, turn upside down (use to hold all discarded
packaging).
- Remove the pedestal mount plate from the front of the
wood fire.
- Lift off the top grill and place somewhere safe. Be careful
not to chip the enamel coating.
- Open the door 90 degrees and lift the door off the hinge
and place somewhere safe. Be careful not to chip the
enamel coating.
- Remove pedestal base (use baffle lifters with Ambie Plus,
instructions taped to front of inside firebox door opening)
- Remove the bolt bag and side brick pack, and baffle lifters
if assembling the Ambie Plus.
- Fit the pedestal base to the pedestal mount using 4x M6 x
10mm socket screws with 4x M6 flat washers. Prior to doing
this you can pre-mark the floor protector with the 2 fixing
points, by placing the pedestal mount plate on the floor
protector, using the (X) as detailed on diagram 1 as the
flue centre point.
- Once the pedestal base is screwed to the pedestal mount
plate, remove the 2 tek screws at the base of the inside of
the firebox that are fixing the wood fire to the pallet.
- It is recommended that 2 people work together with this
step. Grab the underneath top of the firebox door opening
with one hand, holding the flue spigot with the other, slowly
lift the front of the wood fire all the way back and rest the
wood fire on it’s rear heat shield on the floor. Remove the
packaging pallet.
- Fit the pedestal to the wood fire as detailed in diagram 1,
by using the 4x M6 set screws and M6 flat washers, secure
the pedestal to the wood fire.
- It is recommended that 2 people work together with this
step. Grab the flue spigot with one hand and the other
hand underneath the top of the firebox door opening, lift
upwards standing the wood fire onto it’s pedestal.
- Re-fit the door and top grill.
- Open the door fully and fit the side bricks to each side of
the fire box. Location lugs are fitted to the base and rear
of the firebox to retain the side bricks in position. Refer to
Diagram 2.
Top baffle
Side brick
Front baffle
‘X’
Assembling your Metro wood fire
Diagram 1
Diagram 2
• Ambie One = 1 Piece Top Baffle
• Ambie Plus = 2 Piece Top Baffle
