METRO PROFESSIONAL GSC1100G, Инструкция по эксплуатации

Страница: 16 / 85

15
GB
BEFORE FIRST USE
• Remove all packaging ( Disposal of packaging).
• Check for completeness and transport damage. In case of damage or incomplete delivery please contact your dealer ( Guarantee).
• Clean the appliance ( Cleaning).
• Place the appliance on a horizontal and stable surface with a maximum
incline of 5%. If any incline, please install the incline fixing bracket. For the
installation, refer the picture on the right.
- First, take out the screw at mark 1 and fix the fixing bracket with the screw at
mark 1.
- Drill a hole on the wall at mark 2 and fix the fixing bracket with M6 expansion
bolt.
- Note: screws are not included.
• Try to position the appliance close to a wall, but leave enough space for ventilation to ensure good circulation and efficiency of the
appliance.
• Do not position the appliance in direct sunlight or near any heat sources.
• Protect the appliance from moisture, extreme heat or cold.
• Please see the climate class and matched temperature range for reference:
Test room climate class
Dry bulb temperature Relative humidity
°C %
1 16 80
2 22 65
3 25 60
4 30 55
5 40 40
•
Never use an extension cord – risk of overheating!
If the power cord (5) does not reach the nearest mains outlet, either
rearrange your store layout or ask qualified personnel to fit a new outlet.
• The appliance is fitted with castors (6), so that you can easily move it from one place to another. Warning! Do not move the
appliance across uneven floors or steps.
• If power is cut off, wait for at least 5 minutes before plugging the appliance in again to avoid damaging the compressor.
•
Important!
Allow the appliance to stand upright for 8 hours before connecting to a mains outlet for the first time, in order to allow
the refrigerant to settle.
• The maximum load for a shelf (9) is 30kg.
OPERATION
• Connect the power plug (5) with the mains outlet.
• The showcase starts to work.
• The thermostat (digital temperature controller) is located at bottom of the appliance.
• After a few seconds the LED display (18) shows the actual inner compartment (12) temperature. The cooling indicator (14) lights
up. The showcase automatically begins to cool down to the preset temperature.
• After the inner compartment temperature reaches the preset value, the cooling indicator (14) turns off as long as the inner
compartment temperature is constant.
• The factory pre-set temperature range is between 2°-8°C, dependent upon model. Do not adjust this within the first 24 hours!
After 24 hours adjust the temperature in gradual stages, if necessary.
wall
mark 2
mark 1
floor
fixing bracket