Part# 100951
• REV A
(January 2018) Page
4 of 5
4. Pull back, and fan out, the wire coaxial shield to the ferrule to expose the center con-
ductor insulator and conductor. Use the wire strippers to expose approximately 6mm
(0.25”) of the center conductor (22 AMG, 0.80mm). Gently twist the center conductor
wire, then slide the center core pin onto the center conductor wire and insulator.
5. Push the shield onto the shield side of the center core pin. Slide the ferrule onto the
center core pin to cover 30% of the back end of the center core pin. Trim off the
shield to 30% engagement on the pin. This will allow the ferrule to slide up easier and
still maintain shield engagement. Put the wire strippers in the locked positon and use
the strippers as a drift (stop) for the pin body. This will help you with counter force to
slide the ferrule on. Do not let the center core pin slip while sliding on the ferrule. Do
not let shield wire extrude beyond the ferrule, or it will make installing the connector
difficult. Remove excess coaxial shield that will not fit under the ferrule. Note: The
shield takes the cable load not the center pin conductor.
6.
Crimp the center core pin, using the .041 hole, next to the connector insulation. Use
the kit supplied die and crimping tool. Note: The crush is very light on the center pin
conductor.
Shrink Wrap
12mm
6mm
6mm
