Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws below the ashtray. Unclip the
dash trim bezel. Disconnect the cigarette
lighter wiring and remove the bezel.
Remove (2) bolts securing the rear of the
factory head unit and disconnect the wiring.
ACURA Legend 1990
2
1
Modify the factory radio housing by cutting
and removing the
shaded
portions of the
housing lip.
IF AN EQUALIZER WILL BE INCLUDED:
Slide the aftermarket equalizer into the back of the
Radio Housing.
Using the hardware included with the equalizer, mount the unit to the kit.
(see Fig. A)
IF AN EQUALIZER WILL NOT BE INCLUDED:
Snap the
Equalizer Dummy Plate
into the
Radio Housing.
(see Fig. B)
4
Fig. A
Fig. B
¾"
¾"
¼"
¼"
1"
1"
1¼"
1¼"
Factory
radio
housing
opening
Disconnect the negative battery terminal to
prevent an accidental short circuit. Using a
small screwdriver, unclip the perimeter of the
radio trim bezel. Disconnect the climate
control and rear defroster wiring and remove
the bezel. Remove (4) Phillips screws
securing the factory head unit/trim bezel
assembly. Loosen (2) Phillips screws
securing the back of the head unit to the
metal housing and slide the unit out. (It is
NOT necessary to remove the screws
securing the metal housing to the bezel).
Disconnect the wiring.
ACURA TL 1996-98
2
1
Cut and remove the
TOP
clips from the
Radio Housing.
ALL VEHICLES
2-SHAFT HEAD UNITS:
Slide the aftermarket head unit into the kit and secure with shaft
nuts.
(see Fig. A)
DIN HEAD UNITS:
Cut and remove the shaft supports from the
Radio Housing.
Slide the
DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket
head unit into the cage until secure.
(see Fig. B)
3
4
Fig. A
Fig. B
