Metra Electronics 99-6543HG, Руководство по установке

Страница: 8 / 16

99-6543HG
8
Connections to be made
3.5mm jack - steering wheel control retention:
The 3.5mm jack is to be used to retain audio controls on the steering wheel control.
• For the radios listed below, connect the included female 3.5mm connector with
stripped leads , to the male 3.5mm SWC jack from the 6543 harness .
Any remaining wires tape off and disregard.
• Eclipse: Connect the steering wheel control wire, normally Brown , to the
Brown/White wire of the connector. Then connect the remaining steering
wheel control wire, normally Brown/White , to the Brown wire of
the connector.
• Metra OE: Connect the steering wheel control Key 1 wire ( Gray ) to the
Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the
Blue/Yellow wire to the Brown wire.
Note: If the Kenwood radio auto detects as a JVC , manually set the radio
type to Kenwood . See the instructions under changing radio type.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the
Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the
AX-SWC-PARROT (sold separately), and then connect the 4-pin connector from
the AX-SWC-PARROT into the radio.
Note:
The radio must be updated to rev. 2.1.4 or higher software.
• Universal “2 or 3 wire” radio: Connect the steering wheel control wire,
referred to as Key-A or SWC-1, to the Brown wire of the connector. Then
connect the remaining steering wheel control wire, referred to as Key-B
or SWC-2, to the Brown/White wire of the connector. If the radio comes with
a third wire for ground, disregard this wire.
Note: After the interface has been programmed to the vehicle, refer to the
manual provided with the radio for assigning the SWC buttons. Contact the
radio manufacturer for more information.
• For all other radios: Connect the 3.5mm jack into the port on the radio designated
for an external steering wheel control interface. Refer to the manual provided with
the radio if in doubt as to where the 3.5mm jack goes to.
4-pin harness with yellow RCA jacks:
• If retaining the factory backup camera to the touchscreen display is desired,
connect the Yellow RCA jack labeled “Rearview camera”, to the Yellow RCA
jack from the 6543 harness.
Note: If this method is chosen, the backup camera option must be enabled in
the Configuration Settings Screen.
• Disregard the Yellow RCA jack labeled “AUX video”, it will not be used in
this application.