Metos WD-6E, Инструкция по установке и эксплуатации

Страница: 15 / 52

5HY
,QVWDOODWLRQ
15
:DWHUFRQQHFWLRQV
See the installation drawing and technical specifications.
Make sure that the machine stands horizontally. Adjust, if needed, with the aid of the legs
of the machine.The connections should be equipped with a vacuum valve (11), non-return
valve (12) and stop cock (13). The connections have built-in filters.
The warm water connection is connected to (3). (This is also valid for cold water connect-
ed machines).
'UDLQFRQQHFWLRQ
See the installation drawing and technical specifications.
The drain system is connected to (2). The drain and outlet hose (6) for the hood-lift (WD-
6EA) are connected to the sewer, where they should end above water level.
The drain pipe is connected to (4) in the machine with the drain pump. The hose is con-
nected to the sink with copper pipe (d 22 mm) and it has to be ended at least 25 mm above
the sink edge.
$IWHULQVWDOODWLRQ
6HHDOVR&KDSWHU³2SHUDWLRQ´
Check the following points before using the machine
• the dishwasher has been installed horizontally according to the installation in-
structions.
• all the connections (electricity, water) are tight and correctly made.
)LUVWUXQ
3UHSDUDWLRQV
Check that the strainers and the overflow pipe are in their correct positions. Check also
that the detergent and rinse aid hoses are connected to their respective containers. The
thicker hose is connected to the detergent container. Open the stop cock.
5RWDWLRQGLUHFWLRQRIWKHSXPSPRWRU
The rotation direction can be seen by checking the shaft between the pump and motor,
while the contactor is pressed for a short time. If the motor does not rotate in the direction
indicated by the rotation arrow, alter two of the incoming phases.