Metos MORE ECO 1 GNC Series, Инструкция по установке и эксплуатации

Страница: 24 / 52

24
|
14.1.2020 Rev. 2.1
METOS MORE ECO, MORE ECO 1
Unpacking
Unpack the appliance and check for visible damages.
Packing materials (plastic bags, polystyrene foam, nails, etc.) should be kept out of children’s reach as
they are potential sources of hazard, and they should be properly recycled in compliance with local regu-
lations in force.
Check that the serial number corresponds to the transport documents.
Disposal of the appliance
When the appliance has reached the end of its service life, it must be recycled in accordance with current
regulations. Contact a company which specializes in recycling. The best method to ensure that no one
will remain trapped inside is to take off the door completely.
The appliance must not be disposed of together with household waste and metal scrap. Specially avoid
damaging the refrigeration circuit, particularly near the heat exchanger.
Installation
Before making the connection to the mains, ensure that the voltage and frequency are as indicated on the
appliance nameplate. The nameplate can be found on the wall in the compartment.
The installation of this appliance must be carried out in accordance with the manufacturer’s instructions
and following local regulations.
Never use sockets or plugs without earth connection. The mains socket must be earthed.
The manufacturer declines all responsibility if the appliance has not been installed and connected accord-
ing to the instructions given in this manual.
The use of adapters, multi-plugs and/or extension leads is strictly prohibited.
Positioning
The machine has not been designed to be installed in explosive environments.
Check that the fl oor is able to support the weight of the appliance and that it is level.
Control that the appliance is perfectly level. Regulate the adjustable feet if necessary. Use a level, if needed.
The maximum permissible deviation from the horizontal plane is +/-0.5 degrees.
All four feet should rest on the fl oor. This will ensure proper door operation.
To ensure proper airfl ow and avoid any damage to the refrigeration circuit, allow a minimum side clear-
ance of 30 mm and 500 mm on the upper side.
Do not place the appliance close to heat sources (such as ovens, radiators, etc.) or exposed to direct sunlight and
provide suitable insulation from walls or fl oor if they transmit heat.
Do not install the appliance in places where the temperature drops below +5°C. For indoor use only.
If the appliance has been moved, wait for a while before switching it on again. In particular, if it was not
handled vertically, you need to wait at least 2 hours.
Remove the plastic protection from the external surfaces. Wash the inside part with lukewarm water and
mild soap. Place the appliance as far as possible from heat sources. Do not prevent air from circulating
inside the engine compartment. Keep the keys for locking doors away from children.
STOP
STOP
STOP
STOP
STOP
STOP
STOP