01.09.2015
METOS MINOR 4/LD64
7
17.3.2010
Rev. 1.0
Operation instructions
5
4.2 Operation procedures
4.2.1 Using the range
Switch the appliance off if it is damaged or is malfunctioning. Contact authorised service
personnel using original spare parts for service of the appliance.
During the installation, a mains switch may have been fitted near the range, often on a wall
nearby. Check that the mains switch is in the ON position.
The range is controlled with power regulators and pilot lights.
Operating panel
1.
Spillage tray
2.
Pilot light, cooking plate on
3.
Power regulator, front plate
4.
Power regulator, rear plate
Each cooking plate is equipped with a 4-position power regulator which allows power
regulation in several steps. A green pilot light for every cooking plate indicates that the
plate is on.
Do not leave the cooking plate on without any load, because it then overheats, which con-
siderably decreases the service life of the plate. By turning the cooking plate off when not
needed energy is saved and a cooler working environment is achieved.
If there are longer interruptions in the electricity distribution, all power regulators of the
range should be set to the 0 position. This should be done in order to prevent unexpected
start-up of the range when the electricity distribution is restored.
The hob is controlled with power regulators and pilot lights
Operating panel
1. Spillage tray
2. Pilot light, cooking plate on
3. Power regulator, front plate
4. Power regulator, rear
Each cooking plate is equipped with a 4-position power regulator which allows power
regulation in several steps. A green pilot light for every cooking plate indicates that the
plate is on.
Do not leave the cooking plate on without any load, because it then overheats, which considerably
decreases the service life of the plate. By turning the cooking plate off when not
needed energy is saved and a cooler working environment is achieved.
If there are longer interruptions in the electricity distribution, all power regulators of the
range should be set to the 0 position. This should be done in order to prevent unexpected
start-up of the range when the electricity distribution is restored.
4.2.2. Using the oven
The oven is operated with a thermostat and Indication lamps.
1
2
3
Control panel
1 Red indicator lamp
2 The thermostat
3 Thermostat indicator lamp
A thermostat and indicator lamps monitor op-
eration of the oven.
The thermostat may be set at temperatures
between 100°C and 270°C
