Meto mn-4, Руководство по эксплуатации, Страница: 16 / 61

12
mn-4203
3.2.1 Loading Media for Peel Configuration
1. Open the cover.
2. Push the Printhead Latch toward the back of the printer and raise the
Printhead Carrier Assembly.
3. Place a roll of media (labels facing up) on the media hub and insert
them into the printer. Slide the Media Hub Flange against the roll of
media.
4. Pull the Peel Lever forward to the ‘Open’ position.
5. Remove 6
″
(152 mm) of labels from the backing. Route the backing
over the Platen and Peel Bar and behind the Peel Roller and Fascia
as shown below.
6. Push the Peel Lever back to the ‘Closed’ position
7. Close the printhead carrier assembly and press down until it locks
into place.
8. Close the cover and press the ‘Feed’ button several times to feed the
media and ensure proper tracking. The labels will separate
automatically as it is feed through the printer. If the printer does not
correctly sense the top of each label it may be necessary to perform
the Calibration Procedure, Section 4.5.