6
f) Keep cutting tools sharp and clean.
Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed.
Use of the
power tool for opera
tions diff
erent from those
intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified
repair person using only identical
replacement parts.
This will ensure that
the safety of the power tool is maintained.
4. Special safety instructions
Safety Warnings Common for Grinding,
Sanding, Wire Brushing or Abrasive Cutting-
Off Operations
• This power tool is intended to function as a
grinder, sander, wire brush or cut-off tool.
Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool.
Failure to follow all instructions
listed below may result in electric shock, fi e and/
or serious injury.
• This power tool is not recommended for
polishing.
Operations for which the power
tool was not designed may create a hazard
and cause personal injury.
• Do not use accessories which are not
specifically designed and recommended by the
tool manufacturer.
Just because the accessory
can be attached to your power tool, it
does not assure safe operation.
• The rated speed of the accessory must be at
least equal to the maximum speed marked
on the power tool.
Accessories running faster
than their rated speed can break and fly apa t.
• The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool.
Incorrectly sized
accessories cannot be adequately guarded
or controlled.
• The arbor size of wheels, flanges, backing
pads or any other accessory must properly
fit the spindle of the power tool.
Accessories
with arbor holes that do not match the
mounting hardware of the power tool will run
out of balance, vibrate excessively and may
cause loss of control.
• Do not use a damaged accessory. Before
each use, inspect the accessory such as
abrasive wheels for chips and cracks, backing
pads for cracks, tears or excess wear, wire
brushes for loose or cracked wires. If power
tool or accessory is dropped, inspect for
damage or install an undamaged accessory.
After inspecting and installing an accessory,
position yourself and bystanders away from
the plane of the rotating accessory and run the
power tool at maximum no-load speed for one
minute.
Damaged accessories will normally break
apart during this test time.
• Wear personal protective equipment.
Depending on application, use face shield,
safety goggles or safety glasses. As
appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments.
The eye protection must
be capable of stopping flying deb is generated by
various operations. The dust mask or respirator
must be capable of filt ating particles generated
by your operation. Prolonged exposure to high
intensity noise may cause hearing loss.
• Keep bystanders a safe distance away from
the work area. Anyone entering the work area
must wear personal protective equipment.
Fragments of workpiece or of a broken
accessory may fly way and cause injury beyond
immediate area of operation.
Содержание S1M-GW20-115
Страница 1: ...Translation of the original instructions ANGLE GRINDER US S1M GW20 115...
Страница 2: ...2 1 2 3 1 2 3 5 4 3 4 B A a 6 7...
Страница 3: ...3 1 0 4 6 8 5 7 9 2 5...