10
6. Layout
1.
Spindle lock
2.
ON/OFF switch
3.
Additional handle
4.
Protective cover for grinding
5.
Flange nut wrench
6.
grinding wheel:φ115*6*φ22.22(black)
7. cutting wheel
:φ115*3*φ22.22(black)
7. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
7.1 Fitting the additional handle (Fig. 2)
.
The angle grinder must not be used without the
additional handle (3).
.
The additional handle can be secured in any of 2
positions (A, B).
Tool side
Suitable for
Left (position A)
Right-handed users
Right (position B)
Left-handed users
7.2 Setting the guard (Fig. 3)
• Switch off the ool. Pull the power plug.
• Adjust the guard (4) to protect your hands so
that the material being ground is directed away
from your body.
• The position of the guard (4) can be adjusted to
any specific orking conditions. Undo the screw
(a) and turn the cover (4) into the required
position.
• Ensure that the guard (4) correctly covers the
gear wheel casing.
• Retighten the screw (a).
• Ensure that the guard (4) is secure.
Never use the angle grinder without the
guard.
7.3 TEST RUN FOR NEW WHEELS
Allow the right-angle grinder to run in idle for at
least 1 minute with the grinding or cutting wheel
fit ed in place. Vibrating wheels are to be replaced
immediately.
8. Operation
8.1 SWITCH (Fig. 4)
To help prevent accidents, the right-angle grinder
is equipped with a safety switch. To turn on the
machine, push the switch forward and push down
until it latches in place. To turn the right-angle
gr
inder off
, push the switch down. It will then
jump back to its original position.
Wait until the machine has reached its top
speed. You can then position the angle grinder
on the workpiece and machine it.
8.2 Changing the wheels (Fig. 5)
Use the face spanner (5) supplied to change the
wheels.
Pull out the power plug.
• Simple wheel change by spindle lock:
• Press the spindle lock and allow the grinding
wheel to latch in place.
• Open the flange nut with the fa e spanner.
(Fig. 5)
• Change the grinding or cutting wheel and
tighten the flange nut with the fa e spanner.
Important!
Only ever press the spindle lock when the
motor and grinding spindle are at a standstill!
You must keep the spindle lock pressed while
you change the wheel!
For grinding or cutting wheels up to approx. 3
mm thick, scr
ew on the flange nut with the fla
t
side facing the grinding or cutting wheel.
8.3 Flange arrangements when using grinding
wheels and cutting wheels (Fig. 6-9)
• Flange arrangement when using a
depressedcentre or straight grinding wheel (Fig.
Содержание S1M-GW20-115
Страница 1: ...Translation of the original instructions ANGLE GRINDER US S1M GW20 115...
Страница 2: ...2 1 2 3 1 2 3 5 4 3 4 B A a 6 7...
Страница 3: ...3 1 0 4 6 8 5 7 9 2 5...