METER TEROS 06, Руководство пользователя

Страница: 16 / 18

14
SERVICE
4. SERVICE
This section describes the calibration, maintenance, troubleshooting guidelines, customer support
contact information, and terms and conditions.
4.1 CALIBRATION
Every TEROS 06 sensor is individually calibrated in a water quench at a temperature of
10 °C. No calibration is needed by the customer. The TEROS 06 sensor output temperature
is in degrees Celsius unless otherwise stated in the data logger program, such as in the
preferences in ZENTRA software.
4.2 MAINTENANCE
TEROS 06 may be returned to METER for maintenance in the following areas: system
inspection, recalibration, and instrument cleaning. Contact
Customer Support for more
information.
4.3 TROUBLESHOOTING
Table 2 lists common problems and their solutions. If the problem is not listed or these
solutions do not solve the issue, contact Customer Support .
Table 2 Troubleshooting the TEROS 06
problem possible Solutions
Data logger is not
recognizing sensor
If using a METER logger, update logger firmware.
Check the logger configuration for a non-METER data logger using its
user manual.
Data logger is not receiving
readings from the sensor
Check that the connections to the data logger are both correct and
secure.
Ensure that the data logger batteries are not dead or weakened.
Check the configuration of the data logger through software to
ensure TEROS 06 is selected.
Ensure the software and firmware is up to date.
Sensor is not responding
Check power to the sensor.
Check the sensor cable and connector integrity.
Check that the data logger wiring is correct ( Section 2.3 ).
Cable or connector failure
If a stereo plug or M12 connector is damaged or needs to be
replaced, contact Customer Support for a replacement connector
and splice kit.
If a cable is damaged, follow the guidelines in Section 2.3.2 for wire
splicing and sealing techniques.