METER ATMOS 41, Руководство пользователя

Страница: 6 / 37

3
2. OPERATION
Please read all instructions before operating the ATMOS 41 to ensure it performs to its
full potential.
2.1 INSTALLATION
Follow the steps listed in Table 1 to set up the ATMOS 41 and start collecting data.
Table 1 Installation
Tools Needed
Wrench 13 mm (1/2 inch)
Secure mounting location
Mount
(if using ATMOS 41 compass-corrected wind direction, mount on nonferrous pipe)
• meteorological stand
• pole in cement
• tripod
Diameter: 31.8 to 50.8 mm, 1.25 to 2.0 inch
NOTE: Smaller mounts are compatible if washers are added to the V-bolt (not included).
Standard pipe sizes that are compatible are 1.0-, 1.25-, and 1.5-in diameter pipes. Square
tubing with a width of 1.25 to 2.0 in or T-posts can also work as mounting options.
Preparation
Consider the Surroundings
Avoid obstructions.
Ensure that site selection is far from wind obstruction.
Make sure surrounding objects will not shade the solar radiation sensor.
Conduct System Check
Verify all sensors read within expected ranges (see Section 3 on page 9 ).
Adjust Pole Height
Many installations require the ATMOS 41 to be mounted 2 m above ground, but
this can be adjusted based on the specific application.