15
sure not to pinch the media;
8.
Turn the lever clockwise to close the Printhead Module;
9.
Close the cover and turn on the printer or press the “FEED”
button if the printer is already on.
Cutting Mode:
The loading guide will be provided with the cutter kit.
Adjusting the Position of Media Sensor
Note: Only applies to the reflective sensor.
1. Lift the top cover.
2. Push the TPH release lever to release the Printhead Module.
3. Lift the Printhead Module to expose the media sensor cover. (Figure
7-1).
4. Remove the media sensor cover and slide the media sensor to the
appropriate position (refer to Figure 7-3, Figure 7-4 and Figure 7-5).
5. Replace the media sensor cover.
www.meteorbarcode.it - [email protected]
Содержание Dali 200dpi
Страница 1: ...www meteorbarcode it info meteorbarcode it ...
Страница 39: ...www meteorbarcode it info meteorbarcode it ...
