Conventional Products—B110LP Plug-In Conventional Low Profile Detector Base 5
Installation Procedures
This section contains installation information for the B110LP plug-in
detector base. Instructions are given for mounting the base, and basic
installation information is provided.
!
CAUTION: Equipment hazard. Do not use in potentially
explosive atmospheres. Do not leave unused wires
exposed.
The detector base mounts directly to 3-1/2 inch (88.9 mm) and 4 inch
(101.6 mm) octagon boxes and 4 inch square boxes, with or without
plaster rings.
To mount the base:
1.
Remove the decorative ring by rotating it in either direction to unhook
the snaps before separating the ring from the base.
2.
Use the screws supplied with the junction box to attach the base to the
box through the appropriate slots in the base (Figure 1).
3.
Position the decorative ring around the base and rotate it in either
direction until the ring snaps into place.
General
Information
Mounting
